Home › Documentation › Project Panel › Scan and Load a Model

Project Panel - Scan and Load a Model

Model button

How it works

Always use the current top model (bdroot) as the target model. Make sure you are in the model you want to work with before clicking this button.

This panel can be used to scan a Simulink model, typically a model-in-the-loop (MiL) model. The scanned data is stored locally, allowing quick access to all signals and parameters within the model.

Click this button to open a popup menu. The options shown depend on the current state of the target model:

  • If the model has never been scanned, you will see Scan.
  • If the model has been scanned but is not currently loaded, you will see Load and Re-scan.
  • If the model is already loaded, you will see Update.

Actions

Scan / Re-scan

Scan and Re-scan do the same thing: perform a full scan of the current model (bdroot), including all referenced models. All scanned data is saved locally and the model information is loaded into the GUI.

The first scan may take a few minutes depending on the size of the model. Use Re-scan to discard previously saved data and start fresh.

Load / Update

Load and Update do the same thing: check whether any model files have changed since the last scan. Only changed files are re-scanned. The saved data is then updated and the model information is loaded into the GUI.

This is faster than a full scan and is the normal way to refresh data after editing a model.